Start and End Cut
How to Select a Start and End Cut
At some points in the program, you will want to select a start and end cut,
that is specify a section of the track. Here is how to do that:
- First, while holding down the shift key, select the start cut
by pressing the left mouse button.
You will then see an annotation, "<--start cut".
- Next, while holding the shift key down, press the right
mouse button where you want the cut to end.
You then have a selection.
If you want to change either cut point, simple repeat steps one and/or two.
Note: Start and End cuts are usually made on the active track.